Pump Chamber

Herculan ConstaBoost™ SSPB-210WSH-EF Models when height is a problem

● Overcome low pressure, undersized or intermittent water service ● Regain pressure lost
to undersized treatment equipment ● Great performance from Low Yield Wells
SSPB-210WSH-EF Models when height is a problem

This SSPB-210WSH-EF-3B has a 1 hp 20 gpm pump, our special spray boom fill to get rid of Sulfur and any gas that may be in the water and an exhaust fan to send it out of the house.
  • Complete, fully automatic Turn Key System
  • More water in less space through 24” doors
  • Only 49” High without optional exhaust fan
  • Increase storage by connecting several tanks using specially designed frames
  • Electric solenoid controlled fill with manual activation feature
  • Built in water meter can be used to set fill rate and tracks total water used
  • Low water cut off protects delivery pump
  • Quietly delivers consistent pressure
  • Powerful – many flow rates available
  • Deliver needed flow rate to intermittent uses from undersized lines & systems
  • Tanks made of HDPE resin meeting FDA
    regulation 21 CFR 177.1520 © 3.1 & 3.2
  • Level controls NSF 61 compliant
  • Check & Cycle Stop of Low Lead Brass
  • Pump contains no brass
  • When used with low yield well adjustable fill rate prevents over pumping of well
  • In Community well systems restricted fill rate relieves strain on community well and pump.
  • Optional UV disinfection systems for inlet, outlet or both
  • Use with chemical feed systems to adjust pH, disinfect etc.
  • Comprehensive manual included
  • Optional Spray Boom to remove Radon, Hydrogen Sulfide and other gases from water
  • Optional exhaust fan for venting gases to outside of building

Save Money on Treatment Equipment or Regain Performance Lost to Undersized Equipment.

Often plumbing performance is seriously degraded when several pieces of water treatment equipment are installed. Sometimes it is because the equipment was not sized for the proper flow rate and sometimes it is because the treatment cannot be done at high flow rates. A Herculan ConstaBoost™ Static Storage System will restore plumbing performance when incoming flow rates are inadequate for any reason.

Many customers have used this equipment to save money on treatment equipment knowing that the installation of an HCB system after the equipment would restore plumbing performance. For example, remove radon or arsenic with a 5 gpm system or use a less expensive UV system installed on the inlet of an HCB and still get 20 gpm peak demand flow rates at consistent pressure to the plumbing.

Single Well

A well of moderate yield can used to supply a large home or even an irrigation system with much less storage than you might imagine. With the tank fill rate restricted to less than the well yield the well is protected from the damage caused by over pumping while the plumbing connected to the output side of the system benefits from high flows at consistent pressure so you would think you were connected to city water. It is possible to run high volume showers, use several bathrooms at the same time or even operate a properly designed irrigation system using a well that would be inadequate using a standard pump/pressure tank system.

Well Share

These arrangements can become a problem, particularly when well yield is barely or less than adequate. A running toilet, stuck stock tank fill or loss of control at any outlet can result in an empty well and everyone out of water.

If each home on the well share has a Herculan ConstaBoost Static Storage System with the fill rate restricted to their share of the water nobody can empty the well. If a toilet runs at their house, their tank could be pumped empty but the well will not be affected, other users will still have water and there will be water to refill the empty tank once the problem is fixed. Built in water meter reveals abusers.

If others on the well share are not interested in an HCB, a single user can install one. The well can still be emptied by someone else’s negligence but the family with the HCB will still have water long after everyone else has run out.

Community Well Systems

Community well systems may have many homes connected. Any well can be affected by drought or competition from other wells so well yield can change. In addition the peak demand need of the system can change depending on the number and age of people who live in the community and by changing times.

Homes that are remodeled are likely to have water saving toilets, faucets and even clothes washers but there is also the possibility that the master bath shower will have body sprays and multiple shower heads. The net result could be a higher required peak demand flow rate so a system that once provided adequate peak demand pressure may not be doing so now.

If well yield has been affected by increased development in the area or drought, the well may be over pumped frequently. Over pumping can strain the well pump and damage the well, further diminishing its yield.

When an HCB System with restricted fill is installed in one of the homes on a Community Well System, strain on the system is reduced and system storage increases. If a 210 gallon HCB were installed in each of 15 houses on such a system the result would add 3,150 gallons of distributed storage and 150 gallons per minute or more of peak demand delivery capacity.

In this way, it is possible to convert a Community Well System that cannot now meet peak demand flow requirements into one that can, even with the addition of several more homes!

Price Quote To receive a price quote on a Well Manager® for your home, please fill out the Residential Sizing Guide. To receive a quote for other applications call 800-211-8070 or include your contact information in an email and we will call you.
Printable Brochure You'll needGet Adobe Reader logoto view the brochure and you can get it here.